3) This is a 1968 Chevrolet convertible with a one piece tilt front clip. Needs full restoration and is missing parts. There is NO TITLE, engine, transmission, convertible top, gas tank, chrome, door latches, and more. What you see in the photos is what you get. Nice rolling chassis project car. Frame appears to be in good condition. Dash pads are in nice shape the rest of the interior is rough. Seats are not for a corvette. Wire harness looks to be there and in good condition. This car originally was a 327/350 horse 4 speed Ralley red. I believe it still has the original 370 gear ratio posi rear end. Considering there is no title I did some research on this Corvette and found it on the Corvette registry this may help get a title and tell some history about it. Sold for $3,450 on June 28, 2017. 2) CAR IS BEING PARTED OUT UNFORTUNATELY TO SAVE ANOTHER 68 C3. 1) Frame off mod rod started. frame cleaned inspected coated. suspension good, body mods done, tilt front one piece, doors sanded sealed blocked, rear spoiler worked in and sealed, hood needs some finishing and blocked. 454 built all new, side pipes, trans gone through original 4 speed, drive shaft reworked, new joints, rear end origional pulled apart checked, sealed, steering gone through. Brakes all redone new parts. Could use some suspension bushings. Car runs and drives well. we pulled out interior to redo.. Have all original parts except bumpers. full dash, guages, radio, door panels, all interior parts, seats. No carpet. Top is white in good shape still on top bow, tires, rims are good almost new tread on tires and no weather checking. 67,659 miles. Colors from the owner. Built date is D27. December 3, 2009. |